Kenworth T600

[Ray]

Thanks guys, cant wait to start the laying down the tape for the stripes n stuff

Just realised I forgot to add the air tanks that should be on the chassis now pullinghair

[Ray]

No sooner had the urge to build again started.....I lost interest pretty much straight away....
I'll try again and make a start on the stripes for the cab and sleeper

[B61 MACK]

Keep working at it at your own speed. yes!

[slowlylearning]

Inspiration will come. That's what it does. It goes in, thats why it's called INspiration not OUTspiration Don't rush or push it. Let creativity fester inside you until you can stand it no longer and literally run to your desk! Did that today and ended up pulling out a kit I haven't looked at in months. Now I'm trying to mix up a convincing purple clear with the red and blue clears

[Ray]

Well bugger me....I achieved something

I'll lay down the Metallic Red tomorrow and hopefully it will look the part crossed




Kinda reminds me of the Singapore Airlines logo in a way

[sandboarder]

[B61 MACK]

[Ray]

Cheers guys, Luke actually sent me some masking tape which I misplaced pullinghair

Found a small roll of tape which was just enough to do this

[B61 MACK]

crossed

[Ray]

The Metallic Red went on really good today, I took some photos, but they look like crap...so I'll give it a few days to cure before peeling the tape off yes!

One of the truck modellers on MCM told me once the paint has dried, put the whole thing in a sink full of warm water for 15 minutes and the tape comes of without any issues........

Anyone tried this method dunno