Kenworth T600

[Ray]

Yay Bodgy, thanks mate

https://www.youtube.com/watch?v=dcLbS0yxzdk

[B61 MACK]

If you are looking for a colour for stripping look at black or as you say the wire. yes!

[Ray]

Black does sound good Allan ,

Bodgy says Barbed Wire, have to thank Sandboarder who mentioned it first

Still got till the end of October to finish this crossed ohno run

[bodgybro]

Do you have barbed wire? I think i saw on a post you had 2 sizes... or was that in 1 of my day dreams? might be the 1 where the leprachaun does some unspeakable things to me.

[Ray]

Do you have barbed wire? I think i saw on a post you had 2 sizes... or was that in 1 of my day dreams? might be the 1 where the leprachaun does some unspeakable things to me.

yeah scroll back through the thread, purchased from Slixx, two sizes, I'll use the small....the other is just too big

[Ray]

I decided not to use that method and carefully peeled the tape off, I'm happy how it's turned out, a few runs, but I have an idea sweating yes!

What it needs now is another colour to break things up a bit (Yellow I'm ) at these points indicated, I'll re tape here and see what happens

Chassis

Chaps,
Can you give me a heads up on what colour would compliment the Red and Silver, I've dragged this out ready to mask it for a third colour.....I'm Tamiya Chrome Yellow or maybe a Green.....Possibly Tamiya Park Green....obviously to cover up where the previous masking didn't sit right magnify

[Luke]

jawdrop
Good to see ya tinkering again mate

Can you give me a heads up on what colour would compliment the Red and Silver,

dunno Blue my 2 cents

[B61 MACK]

If you look at a colour wheel the complimentary is green which is on the other side of the wheel to red.
What you should do is put some red paint on a old body or container then add the silver, then look at green. Colour matching is hard to do you may have to look at a few greens.

[bodgybro]

black

[B61 MACK]

Ya black would work. whathesaid