Kris Walton - 2016 Bushranger FG V8 Ute

[bodgybro]

Will be doing 2 of this for Jenna / Kris



Parts are almost done printing, few resin pieces to make, art work is done just needs to be sized and printed...then the real work begins.

[Ray]

[B61 MACK]

That's going to look way cool. yes!

[dirt devil]

can't wait to see it.

[slowlylearning]

yes! This should be a good one! hi5

[bodgybro]

yes! This should be a good one! hi5

two

[slowlylearning]

Read it properly the second time 'round. Cant wait to see your bench covered in utes! drool2

[bodgybro]

As KC suggested, I am putting up each stage of this build to show how much work goes in to a printed model build.

Printed parts so far

All parts


Bodies


The wheels


The tread


The dash


The front, showing the print striations. this is V9 of the design so the striations have become less with small tweaks.


The rear... unfortunately, the tweaks to reduce striations on the rest of the body, means they have to go somewhere... it's mainly the angle it prints at that gets adjusted to move the striations to a more manageable position. being the tailgate is a flat surface, it makes it easier to smooth them out here than across the bonnet or sides.


More updates to come... seats, brake rotors, grill mesh, diff, chassis, windows, decals, figure

[sandboarder]

[B61 MACK]

The back of the ute looks like wood grain.