Did another print today with a set of wheels and some octagonal steering wheels in different sizes, 2/4 wheels failed but I think that's due to the LCD screen in that particular part of the print-bed spot
All 4 steering wheels were successful though my 3d drawing had a couple of holes in it, so the slicing program bridged them together. I cleaned one up enough to be usable though I'll probably do some other steering wheels in the near future. 
Wheel print needed a lot less cleanup this time thanks to some advice from Bodge. Still need to go back and resize the insert to be slipfit instead of hahing to slightly sant the perimeter and cut away a smidge of boltring haha
Wow.......................
